BEC 6200WZL User Manual download pdf (Page 51)

wireless client to be able to identify the Access Point (AP) of your router. Select the specific ESSID

scanned, with some security settings, you will join this wireless network.

Regulation Domain: There are seven Regulation Domains for you to choose from, including North

America (N.America), Europe, France, etc. The Channel ID will be different based on this setting.

Channel ID: Select the ID channel that you would like to use.

Channel Wdith: Select either 20 MHz or 20/40 MHz for the channel bandwidth. The higher the

bandwidth the better the performance will be.

Tx Power Level: It is function that enhances the wireless transmitting signal strength. User may

adjust this power level from minimum 0 up to maximum 100.

Note: The Power Level maybe different in each access network user premises environment and

choose the most suitable level for your network.

AP MAC Address: It is a unique hardware address of the Access Point.

AP Firmware Version: The Access Point firmware version.

WPS service: Enable / disable

WPS State: Current WPS state in AP. It is be used for WCN (Windows Connect Now).

 Configured: This AP is be configured via WPS. It is not allow to configure via WCN.

 Unconfigured: This AP is un-configured via WPS. It can be configure via WCN.

WMM: This feature works concurrently with QoS that enables the system to prioritize the flow of data

packets according to 4 categories: Voice, Video, Best Efforts and Background.

 Enable: Click to activate WMM feature.

 Disable: Click to deactivate WMM feature.

Wireless Distribution System (WDS)

It is a wireless access point mode that enables wireless link and communication with other access

point. It is easy to be installed, simply define the peer’s MAC address of the connected AP. WDS takes

advantages of cost saving and flexibility which no extra wireless client device is required to bridge

between two access points and extending an existing wired or wireless infrastructure network to

create a larger network.

WDS Service: The default setting is Disable. Check Enable radio button to activate this function.

1. Peer WDS MAC Address: It is the associated AP’s MAC Address. It is important that your peer’s

AP must include your MAC address in order to acknowledge and communicate with each other.

2. Peer WDS MAC Address: It is the second associated AP’s MAC Address.

3. Peer WDS MAC Address: It is the third associated AP’s MAC Address.

4. Peer WDS MAC Address: It is the fourth associated AP’s MAC Address.

Note: For MAC Address, Semicolon (;) or Dash (-) must be included.

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 127 128

No comments

BEC 6200WZL User Manual Page 51